Force10 Networks PSeries 100-00055-01 Manuel d'utilisateur télécharger pdf (Page 27)

P-Series Installation and Operation Guide, version 2.3.1.2 27

Managing Rules, Policies, and Firmware

Enter the m command from the GUI command line (see “GUI Commands” on page 26) to invoke a menu

that enables you to manage dynamic rules, capture/forward policies, and firmware. Three options are

available; they are shown in Figure 14 and described in Table 4.

Figure 14 Rule Management GUI

fn9000011

PNIC0 Not Active

u Brings the OS network interface up and enables matching. This is similar to the command s, but it

does not load/reload the driver. It is only valid after the command s has been executed.

x Toggles the direct memory access (DMA) off and on to enable or disable capturing to the host,

respectively.

z Disables the DMA and brings the interface down, in succession. This is equivalent to issuing the

commands pnic down and pnic off, in succession.

Note: Commands 1, 2, 3, 4, and 5 are for engineering use only. If you enter a command 1 through 5 by

mistake, enter 0 to return to the runtime statistics screen.

Table 3 GUI Commands

Command Description

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 131 132

Pas de commentaire

Force10 Networks PSeries 100-00055-01 Manuel d'utilisateur Page 27